Diorama Accessories Acrylic Brick Standard Type [GSWD-12560]

Product description ※Please note that product information is not in full comprehensive meaning because of the machine translation.

Product Description ■ It is an acrylic mold that you can make real bricks and paving stones equivalent to 1/35, 1/32 and 1/48.
You can reproduce various surface textures and patterns that reproduce real bricks and make high-quality diorama accessories.
The material to be filled in the mold is a synthetic resin paper clay that hardens by air drying such as modeling clay DAS.
How to use :
1. Cleanly remove dust and dirt from the mold.
2. Attach cooking paper, wet kitchen paper, masking tape, [GSWD wd - 10354] Paint Equipment S (A6) size Mylar stencil sheet to one side of the mold.
3. Place the mold on a flat surface with the side to which the sheet is attached.
5. Flatten the surface. Press down on the rounded clay with your fingers to fill the mold. Remove excess clay on the surface with the attached plastic spatula.
6. Dry the clay until it hardens. The paper clay shrinks slightly when dried.
7. Once the clay has completely hardened, peel the sheet off the mold slowly and carefully.
8. Remove the brick until it hardens. Lightly poke the brick with the round tip of the brush handle and push it out of the mold.
8. Remove the brick until it hardens. Lightly poke the brick with the round tip of the brush handle and push it out of the mold.
9. Smooth out the sharp edge of the brick. Place the brick on the palm of your hand, grasp it with both hands, lightly shake it.
10. Use bricks. Can be used for road paving and wall decoration. Use instant adhesive or acrylic sealer such as [GSWD-4149] medium decoupage mat (matte) for adhesion.
Scale : 1/35 (1/48-1/32)
Brick Size : Approx. 2.8 x 5.7 mm
Brick Thickness : Up to 3 mm
Mold Size : Approx. 6 x 11 cm
Contains 2 sheets of 75 models with plastic spatula.